AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Antique Firearm Serial Numbers4/25/2021
We also proposed that all other required markings, including the special markings for semiautomatic assault weapons, be cast, stamped (impressed) or engraved to a depth of at least.005 inch. We did not propose to require a minimum height requirement of 332 inch for all identification markings since such a requirement would make it difficult to fit all the information on a firearm, particularly in the case of handguns.Be sure to leave feedback using the Help button on the bottom right of each page.
Counts are subject to sampling, reprocessing and revision (up or down) throughout the day. ![]() Antique Firearm S Serial Numbers And ASpecifically, we are requiring a minimum height of 1116 inch and a minimum depth of.003 inch for serial numbers and a minimum depth of.003 inch for all other required markings. We believe that these minimum standards are necessary to ensure that firearms are properly identified in accordance with the law. In addition, the final regulations will facilitate our ability to trace firearms used in crime. The serial number must be engraved, cast, or stamped on the receiver or frame of the weapon in such manner as the Secretary of the Treasury prescribes by regulation. The serial number may not be readily removed, obliterated, or altered. Section 5842 also requires the firearm to be identified by the name of the manufacturer, importer, or maker, and such other identification as the Secretary may prescribe by regulation. The serial number must be placed in a manner not susceptible of being readily obliterated, altered, or removed. Gun Control Act of 1968, 101, 82 Stat. To accomplish this objective, section 178.92 requires that each manufacturer or importer utilize an individual serial number for each firearm manufactured or imported and prohibits the duplication of any serial number placed by the manufacturer or importer on any other firearm. Furthermore, section 922(k) of the GCA makes it unlawful for any person to transport, ship, possess, or receive, in interstate or foreign commerce, any firearm that has had the importers or manufacturers serial number removed, obliterated, or altered. ![]() The systematic tracking of firearms from the manufacturer or U.S. Our National Tracing Center (NTC) maintains the capability to trace recovered firearms used in crimes. Over the years, the NTC has experienced a substantial increase in the number of requests received for crime gun traces by Federal, State, and local law enforcement agencies. The total number of requests for gun traces increased from 77,000 in 1995 to approximately 200,000 in 1997. The lack of specific minimum standards has caused problems for licensees in properly recording identifying information in their required records, particularly with respect to serial numbers that are very small or are not applied to a uniform depth. Moreover, worn, hard-to-read markings often result in State and local law enforcement officers forwarding erroneous information to ATF in connection with a trace request. Serial numbers that are stamped very lightly on the frame or receiver of the firearm are more susceptible to being easily obliterated, altered, or removed. These problems often hinder our efforts to trace a particular firearm. The Johns Hopkins Center for Gun Policy and Research provided us with the following information. Nationwide it is estimated that between 9 and 20 percent of the crime-guns recovered have had their serial numbers removed. We also proposed that all other required markings, including the special markings for semiautomatic assault weapons, be cast, stamped (impressed) or engraved to a depth of at least.005 inch. We did not propose to require a minimum height requirement of 332 inch for all identification markings since such a requirement would make it difficult to fit all the information on a firearm, particularly in the case of handguns.
0 Comments
Read More
Leave a Reply. |